Sixty Mil or Eighty: Choosing TPO Thickness — A Practical Guide
How to read an estimate for a TPO roof in Toluca Lake, and what to compare line by line.
What follows is the practical version — what actually matters on tpo roofing in Los Angeles, what we look at when we are on a roof, and the parts that are usually left out of a sales conversation.
What actually matters
White single-ply membrane covers most of the commercial stock in this city, and for good reason: it is the most effective cool roof widely available, and on a large warehouse the cooling saving alone can justify the specification. Reflectivity does fall as the surface weathers and collects the grit that hangs in the basin air, but even a dirty white roof runs far cooler than a dark one.
The detail that is usually left out
Thickness is the specification decision that matters. Sixty mil is the sensible minimum for any roof with service traffic; eighty is worth the difference where there is substantial rooftop plant. The seams are heat welded, and a weld is either sound along its whole length or it is not — which is why a proper inspection probes them rather than looking at them. Mechanically fastened systems go down faster and cost less; fully adhered systems perform better under wind uplift at the perimeter.
How Los Angeles changes the answer
Almost every commercial building here carries rooftop HVAC, and the majority of TPO failures attended were caused by another trade rather than by weather. A technician dragging a condenser across an eighty mil membrane will open it, and nobody reports it. Walkway pads to every unit pay for themselves the first time they prevent a puncture over an occupied space.
What we look at on an inspection
- Weld integrity at every lap, probe-tested along the full length
- Punctures and abrasion around HVAC and service routes
- Boot and flashing condition at penetrations
- Ponding persisting beyond forty-eight hours
- Drain clearance and sump condition
- Perimeter termination and edge metal
- Insulation moisture, particularly under any previous patch
Common questions
How long does the work take?
Most residential roofs are two to four days weather permitting, longer where deck repair or a discontinued material is involved.
Do you handle the permit?
Yes. Re-roofing needs one in every jurisdiction we work in, and a contractor who suggests skipping it is telling you something useful about the rest of the job.
The honest summary
Laying new membrane over wet insulation guarantees failure and is the most expensive mistake available on a commercial roof. Moisture readings come first; if the insulation is saturated, that is a replacement rather than an overlay, and any contractor who says otherwise is selling the cheaper job.
Free inspection, drone photography where access is difficult, and a written estimate with deck repair priced per sheet. No obligation.