Can Metal Go Over Existing Shingles? — Common Mistakes
What goes wrong first on a metal roof in North Hollywood, and the signs that show up years ahead.
Understanding why something fails is more useful than a list of symptoms, because the same symptom has several causes and they need different work. Here is what actually goes wrong with a metal roof in North Hollywood, and what it looks like from the ground before it becomes a ceiling stain.
What actually goes wrong
Metal rarely wears out. What fails is the fixing. An exposed-fastener panel is screwed through its face, and every screw carries a rubber washer that hardens in this sun. After fifteen summers those washers shrink, the screws back out, and a roof with two thousand fasteners has two thousand small opportunities to leak.
Why it happens when it does
The cause and the symptom are rarely in the same place. Water tracks, so an entry point and a ceiling stain can be several feet apart. Thermal movement is the detail that decides everything. A long panel in this climate grows and shrinks measurably between a July afternoon and the following dawn, and a fixing system that does not allow for that movement will fight it until something gives. Catching it at that stage is the difference between a repair and a replacement.
How North Hollywood makes it worse
North Hollywood takes the full inland summer with very little relief after dark, and the ultraviolet load on a south-facing slope here is as hard as anywhere in the county. Asphalt ages from the top down under it: once the granules have gone the mat underneath turns brittle and starts to crack. Mostly single-storey post-war housing with later additions, which puts a transition detail in the middle of the roof where two eras of workmanship meet.
What we look at on an inspection
- Fastener condition on any exposed-fix section, including washer hardening
- Clip engagement and any sign of thermal binding along standing seams
- Seam integrity down the full run, not only at the visible ends
- Coating condition, with particular attention to cut edges and scratches
- Sealant at penetrations, end laps and every transition
- Panel oil-canning, which is cosmetic but can point to fixing problems
- Corrosion at eaves, cut edges and any point where dissimilar metals meet
Common questions
Can this be repaired or does it need replacing?
It depends whether the cause is localised or systemic. A failed penetration is a repair; a covering that has gone brittle across the whole roof is not.
How urgent is it?
Anything open before the rains is urgent. Anything cosmetic can wait for a dry-season schedule, which is also when it is cheaper.
The honest summary
Metal is the longest-lived option available here, but only if the fixing system suits the movement. Ask how the panels are held down before you ask what they cost. In North Hollywood the thing to watch is granule loss on the sun-facing slopes, and the junction where an addition meets the original roof.
Free inspection, drone photography where access is difficult, and a written estimate with deck repair priced per sheet. No obligation.
More on Metal Roofing
- Rust and Corrosion on Metal Roofs in Sherman Oaks — Costs and TimelinesMetal Roofing
- Rust and Corrosion on Metal Roofs in Sherman Oaks Village — Myths and FactsMetal Roofing
- Rust and Corrosion on Metal Roofs in Southern California — Costs and TimelinesMetal Roofing
- Rust and Corrosion on Metal Roofs in Sherman Oaks — Myths and FactsMetal Roofing